![]() ![]() Finally, make it tight with the strainer tool. Make sure the rod attached to the lever feeds the overflow head and goes out of the tub. Then hold the head close to the upper body hole of the tub from outside and the faceplate from inside. Now smear some putty on the entrance of the head, then put the rubber gasket on it and again some putty on the gasket. Take off the overflow faceplate with the lever from here. The upper part of the overflow pipe is the overflow head. Also, open up the rod joins from the internal parts. Make sure to take off the tee, main drain pipe, overflow pipe, and the stopper from the assembly. You can take a note if you want to identify the parts better. You cannot install the drain if it’s assembled. Also, you will need a few tools to do the job. So, keep this in your mind before starting the installation. Otherwise, things will be difficult to set up properly. You need easy access to your bathtub to installing the drain. The work is easy but follow the steps sequentially. Here’s the detailed step-by-step guide to install a bathtub drain with overflow. How To Install Bathtub Drain With Overflow Moreover, the overflow mechanism removes the excess water from the tub. Therefore, the stopper will close and stops the water flow. After that, the rocker arm will pull the plug down. If you turn the lever downwards, it’ll pull the rod along with the spring. You can operate the drain with the help of the lever and the stopper. Also, the spring from the overflow joins with the rocker arm inside of the tee pipe. A compression nut and a rubber ring make the joint tighter on either side. In addition, the stopper is connected with a rocker arm and goes inside of the pipe.Ībove all, the overflow section and the main drain connect through a sanitary tee pipe. On the other hand, the main drain comes with a stopper at its opening. After that, all of these go down through the overflow pipe behind the tub. The lever is attached to spring after a sheet with holes and a rod. There’s also an overflow face place to cover the opening. The overflow section consists of a trip lever at its entrance. The overflow part is the upper or the vertical section… and the main drain which is the lower or the horizontal part of the drain. Also, it can block the water in the tub and control the overflow.Ī bathtub drain looks exactly like the alphabet ‘L’. So, know it before going for it.Ī bathtub drain is a drain that connects the bathtub to a waste drain to allow water to flow from the tub. If you are not familiar with the drain and its parts you are going to install, you will face problems. From this guide, you will learn how you can install a bathtub drain kit with overflow. But you don’t know how to install it to use it. Looks like you bought the bathtub drain kit to use in your bathtub.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |